Apollo I/O Board/ESP DSI Panel Assembly
Part Number 197207 is the Apollo I/O Board/ESP DSI Panel Assembly. It consists of a Mounting
Panel that includes both the Apollo I/O Board Assembly (Part Number 197148) and the ESP DSI
Assembly (Part Number 197146). The panel dimensions are 14” x 20” with the mounting holes
lined up on 12” vertical and 18” horizontal centers.
This Mounting Panel is designed to mount on the inside of the door of a Vector Plus drive in
the area reserved for options mounting. It can also be used as a convenient mounting panel
for use in applications where an Apollo Intelligent Control System is being added to an existing
Variable Speed Drive, Switchboard, or Soft Start product. When using this assembly with a
product other than the Vector Plus, always make sure that adequate space is available to mount
this panel. See Figure 30: Apollo I/O Board/ESP DSI Panel Assembly (Part Number 197207),
page 54 for mounting dimensions.
Figure 30: Apollo I/O Board/ESP DSI Panel Assembly (Part Number 197207)
Two other versions of this Mounting Panel Assembly are available for applications that may not
require both the Apollo I/O Board and the ESP Downhole Sensor Interface.
•
Part Number 197209 consists of the Mounting Panel with the Apollo I/O Board Assembly only.
•
Part Number 197208 consists of the Mounting Panel with the ESP DSI Assembly only.
The Apollo I/O Board Assembly and the ESP DSI Assembly are also available as standalone
items. Each item is provided with its own compact mounting plate.
•
Part Number 197148 is the Apollo I/O Board Assembly only.
•
Part Number 197146 is the ESP DSI Assembly only.
The Apollo I/O Board Assembly is also available with the Zenith Sensor Interface as shown in
Figure 31: Zenith Configuration-Drawing 1, page 55.
To Next Page