Copyright 2020 Baker Hughes Company. All rights reserved.
Table 19: System State Values (cont'd.)
The drive has started and is ramping up to the
Start Frequency.
The drive is running in an alternate run mode.
These modes must be set up by Level 2 or
Level 3 users.
The mode name may be changed to better
reflect the operation being performed. For
example, Run Mode 2 could be programmed
to run the drive for a fixed amount of time at a
higher drive frequency to drain off excess fluid
in the well. “Run Mode 2” could be renamed
“Draining” to better reflect the operation being
performed.
The drive is running in an alternate run mode.
These modes must be set up by Level 2 or
Level 3 users.
The mode name may be changed to better
reflect the operation being performed.
*Timed and/or Triggered restarts may occur if the drive is not locked-out. Do
not clear a lock-out until it is safe to start the drive.
3.6.6
Trigger Ticker
The Trigger Ticker is shown on select screens. The Trigger Ticker is a changing 1 line marquee
that includes relevant information including Drive Name, Drive Control Mode, Motor Direction,
and the first five items from the Relevant Triggers screen.
3.7
User Levels
The Apollo system supports three user levels denoted Level 1, Level 2, and Level 3. Each user level
has specific privileges.
To Next Page
Loading...