To send files to BH for review or troubleshooting, do the following:
•
Insert the USB Flash drive into your computer.
•
Navigate to the folder \Site Name on the USB Flash drive.
•
Right-click the folder Well Name and select the Sent To option and then select
“Compressed (zipped) folder from the pop-up menu.
•
Wait for the data to be compressed.
•
Send the file Well Name.zip to BH at: http://bench.ge.com/559607/portal/66642 with a
description of the problem the pumping system is experiencing.
•
If the compressed file is too big to send by e-mail (current limit
is 10MB), use the following link and Upload the zip file:
http://bench.ge.com/559607/portal/66642.
3.9.6
Automatic Screens
Drive State transitions can be programmed to display screens automatically. By default, the
following automatic screen transitions are active.
Drive State: Lock Out
On a state transition to lock out, the Fault Status screen is automatically displayed.
The fault or faults that caused the lock out will be displayed.
This screen will be shown if restarts are disabled (ManualStartOnly is set to true) or if all the
restarts for the fault have been used.
To Next Page
Loading...