Baker Hughes Apollo 3 - 3.2.2 Apollo I;O Board Assembly

Copyright 2020 Baker Hughes Company. All rights reserved.
Page 29 of 277
Table 5: USB Devices Part Number (cont'd.)
Device
Part Number
USB to USB Adapter
197351
(Allows use of the USB to WIFI Adapter inside plastic door)
Other USB devices that can be used with the Apollo HMI include:
Table 6: Other USB Devices
Device
Description
Other flash drives
Most USB flash drives will work with the Apollo
HMI. If you are unable to use the 810280
device, the SanDisk Cruzer is recommended.
USB Keyboard/Mouse
Standard USB keyboards and mice work with
the Apollo HMI.
Users are strongly discouraged from using any USB device not listed above. Such
devices will likely not work and could impair system functionality.
3.2.2 Apollo I/O Board Assembly
The Apollo I/O Board Assembly provides an I/O interface for the Apollo system. It communicates
the information it gathers to the CPU Board via the Apollo Sub-System RS-485 Communication
port. Features include:
• Quantity 8-12 bit Analog Inputs (0-5V, 0-10V, 4-20mA)
• Quantity 12- Digital I/O (can be programmed as either inputs or outputs) (AC or DC modules)
• Quantity 2- 12 bit Analog Outputs (0-10V)
• Backspin inputs
• PT Voltage Inputs (3 Phase AC)
• CT Current Inputs (3 Phase AC)
The Apollo I/O Board Assembly is not always required since the Vector VII and Vector
Plus power modules have enough I/O for many ESP applications.