BENSHAW RSi H2 Series - Page 118

Parameter Descriptions
106
890053-00-02
Run Command and Fwd/Rev Command Using Multi-function Terminal – Setting Details
Code
Description
DRV-06
Cmd Source
Set to ‘2 (Fx/Rx-2)'.
IN-65–71
Px Define
Assign a terminal for run command (Fx).
Assign a terminal for changing rotation direction (Rx).
5.1.3.4 RS-485 Communication as a Command Source
Set DRV-06 (command source) in the to ‘3 (Int 485)’. Control the inverter with upper-level controllers
(PCs or PLCs) via RS-485 communications using the S+, S- terminals. For more details, refer to 10 RS-
485 Communication Features on page 299.
Communication as the command source
Group
Code
Name
LCD Display
Parameter Setting
Setting Range
Unit
DRV
06
Command source
Cmd Source
3
Int 485
0–5
-
COM
01
Integrated
communication
inverter ID
Int485 St ID
1
1–MaxComID*
-
02
Integrated
communication
protocol
Int485 Proto
0
ModBus
RTU
0–6
-
03
Integrated
communication
speed
Int485 BaudR
3
9600
bps
0–8
-
04
Integrated
communication frame
setup
Int485 Mode
0
D8 / PN
/ S1
0–3
-
*If COM-02 is set to ‘0’ (Modbus RTU), MaxComID is ‘250’. If set to ‘4’ (BACnet), MaxComID is ‘127’.