Step 1 Terminal Cover and Cable Guide
The terminal cover and cable guide must be removed to install cables. Refer to the following
procedures to remove the covers and cable guide. The steps to remove these parts may vary
depending on the inverter model.
Loosen the bolt(s) that secure the terminal cover. Then remove the cover by lifting it from the bottom and
away from the front.
240V: 7.5 HP ~ 25 HP (5.5 kW ~ 18.5 kW) 240V: 30 HP ~ 60 HP (22 kW ~ 45 kW)
480V: 7.5 HP ~ 40 HP (5.5 kW ~ 30 kW) 480V, 575V: 50 HP ~ 125 HP (37 kW ~ 90 kW)
575V: 7.5 HP ~ 40 HP (5.5 kW ~ 30 kW)
240V: 75 HP ~ 125 HP (55kW ~ 90 kW) 480V: 400 HP ~ 800 HP (250 kW ~ 500 kW)
480V: 150 HP ~ 300 HP (110 kW ~ 185 kW)
To Next Page
Loading...
