2-39
Confidential
Print Unable E1 Turn the power off and
then back on again.
Program error
E100 2-82
Print Unable E5 Turn the power off and
then back on again.
Detected an error in the main
PCB.
E500 2-83
Print Unable E6 Turn the power off and
then back on again.
Detected an error in the main
PCB.
E600 2-83
Print Unable E7 Turn the power off and
then back on again.
Detected an error in the main
PCB.
E701 2-83
E702 2-83
Print Unable E9 Turn the power off and
then back on again.
An error occurred while initializing
the NFC.
E900 2-83
Print Unable ZC Turn the power off and
then back on again.
Detected irregular power supply
for less than 100 times.
6F00 2-55
Replace Toner
-
Dot counter or develop roller
counter of the toner has reached
the upper limit.
4C01 2-50
Screen Init. Fail Remove any material
which is on the
touchscreen.
An error occurred while initializing
the touch panel. D800 2-82
Self-Diagnostic Turn the power off,
then on again.
Leave the machine for
15 min.
An error occurred in the fuser unit
when the power switch was turned
ON or sleep mode was released.
6901 2-54
Will automatically
restart within 15
minutes.
Rechecking the error after the
power switch was turned OFF and
then ON again because an error
was detected in the fuser unit.
(This message is displayed for
approximately 15 minutes when
the machine is restarted after error
code 6901 has occurred.)
6902 2-54
Size Error Specify the correct
paper size for Tray1.
When printing from paper tray 1, a
paper size not supported for paper
tray 1 was specified from the
driver.
9702 2-80
Specify the correct
paper size for Tray2.
When printing from paper tray 2, a
paper size not supported for paper
tray 2 was specified from the
driver.
9703 2-80
Specify the correct
paper size for Tray3.
When printing from paper tray 3, a
paper size not supported for paper
tray 3 was specified from the
driver.
9704 2-80
Error message
Description
Error
codes
Refer
to:
First line Second line
To Next Page
Loading...
Need help?
General