When active the C-code is enabled for SM-BUS batteries and the following
parameters become available:
1) “Fully Charged” 2) Terminate Charge Alarm 3) Overcharge Alarm 4) Fully
Discharged Alarm 5) Terminate Discharge
Any of the above options can be set to one the following conditions;
1) Finished –will terminate the program successfully on flag
2) Fail –will terminate the program with a failure on flag
3) Ignore – will ignore the flag.
6) Over temperature Alarm options;
1) Ignore – will ignore the flag.
2) Retry x (1~10) – will wait for multiple flag conditions before terminating
with a failure. (Over temperature Only).
Alters the Maximum Discharge Rate field to use the device’s (specified in the
program) Maximum current rate. (Defaults to C8000 maximum of 10A).
To Next Page
Loading...