Canon iPF760 - Page 454

Setting Item Description, Instructions
GL2 Set-
tings
Proces-
singOp-
tion
PageSizeProcess1 Normally, the area available for printing excludes a margin
required by the printer, and images are positioned according-
ly. Selecting On in this setting eliminates any misalignment of
the printing position if the image itself includes a border.
PageSizeProcess2 Selecting On will determine the paper size based on the im-
age rendering area.
GL2 Set Print Print GL2 settings information.
Interface
Setup
EOP Timer Specify the timeout period before cancellation of print jobs
that cannot be received by the printer.
TCP/IP IPv4 IPv4 Mode Choose whether the printer IP address is configured auto-
matically or a static IP address is entered manually.
Protocol DHCP Specify the protocol used to configure the IP address auto-
matically.
BOOTP
RARP
IPv4
Settings
IP Address Specify the printer network information when using a static IP
address.
Enter the IP address assigned to the printer, as well as the
network subnet mask and default gateway.
Subnet Mask
Default G/W
DNS
Settings
DNS Dync update Specify whether DNS server registration is updated automati-
cally.
Pri. DNS SrvAddr
Specify the DNS server address.
Sec. DNS SrvAddr
DNS Host Name Specify the DNS host name.
DNS Domain Name Specify the DNS domain name.
IPv6 IPv6 Support Specify whether to connect via IPv6.
IPv6 StlessAddrs Specify whether a IPv6 stateless address is used.
DHCPv6 Specify whether DHCPv6 settings are used.
DNS
Settings
DNS
Dync
update
Statefull
Addr
Specify whether DNS server registration is updated automati-
cally.
State-
less
Addr
Pri. DNS SrvAddr Specify the DNS server address.
Sec. DNS SrvAddr
DNS Host Name Specify the DNS host name.
DNS Domain Name Specify the DNS domain name.
NetWare NetWare Specify the NetWare protocol. To apply your changes,
choose Register Setting.
Frame Type Specify the frame type to use.
Print Service Choose the print service.
AppleTalk Specify whether to use the AppleTalk protocol. To apply your
changes, choose Register Setting.
Ethernet
Driver
Auto Detect Specify the communication method. To apply your changes,
choose Register Setting.
Choose On for automatic configuration of the LAN communi-
cation protocol. Choose Off to use settings values of
Comm.Mode and Ethernet Type.
Comm.Mode Choose the LAN communication method.
Ethernet Type Choose the LAN transfer rate.
Menu Settings iPF760
User's Guide
Control Panel Printer Menu
454