2-710
Catalyst 3750-X and 3560-X Switch Command Reference
OL-29704-01
Chapter 2 Catalyst 3750-X and 3560-X Switch Cisco IOS Commands
show lacp
This is an example of output from the show lacp neighbor command:
Switch> show lacp neighbor
Flags: S - Device is sending Slow LACPDUs F - Device is sending Fast LACPDUs
A - Device is in Active mode P - Device is in Passive mode
Channel group 3 neighbors
Partner’s information:
Partner Partner Partner
Port System ID Port Number Age Flags
Gi2/0/1 32768,0007.eb49.5e80 0xC 19s SP
LACP Partner Partner Partner
Port Priority Oper Key Port State
32768 0x3 0x3C
Partner’s information:
Partner Partner Partner
Port System ID Port Number Age Flags
Gi2/0/2 32768,0007.eb49.5e80 0xD 15s SP
LACP Partner Partner Partner
Port Priority Oper Key Port State
32768 0x3 0x3C
This is an example of output from the show lacp sys-id command:
Switch> show lacp sys-id
32765,0002.4b29.3a00
The system identification is made up of the system priority and the system MAC address. The first two
bytes are the system priority, and the last six bytes are the globally administered individual MAC address
associated to the system.
Port Number Port number.
Port State State variables for the port, encoded as individual bits within a single octet with these
meanings:
• bit0: LACP_Activity
• bit1: LACP_Timeout
• bit2: Aggregation
• bit3: Synchronization
• bit4: Collecting
• bit5: Distributing
• bit6: Defaulted
• bit7: Expired
Note In the list above, bit7 is the MSB and bit0 is the LSB.
Table 2-39 show lacp internal Field Descriptions (continued)
Field Description
To Next Page
Loading...
Need help?
General
