Cisco D9854 - Page 136

4-74 Model D9854 Advanced Program Receiver Installation and Operation Guide 4021470 Rev D
Setup Menu: Outputs: TS Out: DPM
GLOBAL
Resync All:
Description: This resynchronizes all DPM output with the PMT data for all
program entries.
Parameters: ASI or MOIP1.
Regenerate
Description: This selects whether to regenerate the PSI tables.
Parameters: Always or As Needed (only if the content has changed).
Copy:
Description: This copies all DPM data from either the ASI output to the MOIP1
output (MPEG over IP) or from the MOIP1 output to the ASI output
depending on your selection.
Parameters: ASI->MOIP1 or MOIP1->ASI.
ASI/MOIP1
PE
Description: This selects the DPM Program Entry to view/modify.
Parameters: 1 to 16.
InCh
Description: Displays the input channel of the current PE.
Parameters: 1 to 65535.
PMT
Description: This is the input PMT. This value is only to map to the output PMT
if the PE Action is set to MAP.
Parameters: 1 to 8192.
Act
Description: Selects the DPM program action for the PE.
Parameters: Pass, Map or Drop. Default is Pass.
OutCh
Description: This selects the DPM output channel you want to map to the input
channel (InCh). This value is only used if the PE Action is set to
MAP.
Parameters: 0 to 65535.