3-10 Model D9854 Advanced Program Receiver Installation and Operation Guide 4021470 Rev D
Connecting the Ethernet Management Interface
The Ethernet Interface
The RJ-45 interface for 10/100/1000 BaseT Ethernet is currently intended for
upgrading/downloading the software application.
Note: You must set up the IP address, the default gateway and the subnet mask to
match the network connection. This is done through the front panel menu. For
further information, see Set up for Network Connection, page 1-3.
Informative Notes
Proper cables are required for reliable Ethernet operation; to run up to a maximum
segment length of 100 m and up to 100baseT, the cable has to comply with the EIA/
TIA Category 5 (or higher) wire specifications, and for 1000baseT, Category 6 is
required.
To Connect the Ethernet Interface
1. Connect an RJ-45 cable between the Ethernet connector on the D9854 receiver
and the Ethernet port of your PC.
You need to set up the IP address on the D9854 receiver (via the front panel
display). For information on setting up the IP address via the front panel, see Set up
for Network Connection, page 1-3.
To Next Page
Loading...
Need help?
General
