EasyManua.ls Logo

Cisco D9854 - Factory Default Settings; ASI out for both Models; D9854 Advanced Program Receiver

Cisco D9854
344 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
4021470 Rev D D9854 Advanced Program Receiver Installation and Operation Guide 1-7
ASI Out for both models
1. Press MENU to move to the MAIN MENU.
2. Press
! to move to the Setup menu. Press SELECT.
3. Press
# to move to the Outputs menu. Press SELECT.
4. Press
! to move to the TS Out menu. Press SELECT.
5. Press SELECT to access the ASI menu. Press
#. Press SELECT. Use "# to
select the output mode. The factory default is “No Output”. It is recommended
to set the Output Mode to MAP Svc Chans Only. Refer to Factory Default
Settings, page B-2, for information on the default settings in order to choose the
desired Output Mode. Press SELECT. Press
! to select “YES” if requested to
“RESYNC ALL?”. Press SELECT. Press
! to move to Descrambling Mode
Menu. Press SELECT. Use
"# to select the scrambling mode. Press SELECT.
6. Press APPLY. Press SELECT.
7. Press MENU 5 times to return to the startup menu.

Table of Contents

Other manuals for Cisco D9854

Related product manuals