4021470 Rev D D9854 Advanced Program Receiver Installation and Operation Guide 4-7
Front Panel Setup
Locking/Unlocking the Front Panel
Depending on the customer’s default settings, the receiver is shipped with a locked
or unlocked front panel. You can lock or unlock the front panel using the front
panel keypad.
Proceed as follows to unlock the front panel using the front panel keypad:
1. From the Startup screen, press SELECT and then INFO. This will unlock the
front panel keypad and allow you make changes to all the operating parameters;
however, if the keypad remains untouched for the duration of the set timeout
period (default is 60 seconds), the keypad will change back to the Lock state
unless you change the keypad state on the Admin Menu. Likewise you toggle
the keypad lock state back using SELECT and INFO at any time provided the
KB Lock state on the Admin Menu is Enabled. For more information on front
panel keypad buttons, see Keypad Convention, page 4-4.
Note: If the lock level is 3 or 4, you must enter a password to unlock the front
panel. For more information on lock level password, see Setup Menu: Admin,
page 4-26.
2. To disable Lock completely, navigate to Setup, Admin, KB Lock in the LCD
display and press the SELECT key.
3. Change the KB Lock state from Enabled to Disabled.
4. The front panel will now be unlocked allowing you to change any of the
operating parameters.
To lock the front panel, perform the same procedure, except use
! to change the
state. In this case you will not be prompted to confirm the operation.
To Next Page
Loading...
Need help?
General
