1-10 Model D9854 Advanced Program Receiver Installation and Operation Guide 4021470 Rev D
Setting the DPM Mode
A program can be set to one of three Digital Program Mapping (DPM) modes,
either Drop, Pass or Map respectively. Refer to Setup Menu: Outputs, page 4-62 for
more information on the DPM modes.
To set the DPM Mode:
1. Press MENU to display the Main Menu.
2. Press
! to move to the Setup menu. Press SELECT.
3. Press
! five times to move to the Outputs menu. Press SELECT.
4. Press
! to move to the TS Out menu. Press SELECT.
5. Press
! twice to move to the DPM menu. Press SELECT.
6. Press SELECT to access the Global menu.
7. Press SELECT to choose ASI for Resync All.
8. Press MENU. Press
! to move to the ASI menu. Press SELECT. Verify the
PE1”InCh” and “OutCh” programs.
9. Press
! three times to choose Act. Press SELECT. Use "# to select the DPM
action for the PID associated with the PE. Press SELECT. Press APPLY.
10. Press MENU six times to return to the start-up screen.
LCD Setting Description
Drop Removes the service and its associated PMT reference from the
transport output.
Pass Permits the source content and PMT reference to appear in the
transport output with the same references unless the source
material is MAPped on another PE.
Map Provides the flexibility to define all the outgoing PID numbers
for a PE, including those not currently on transmission.
To Next Page
Loading...
Need help?
General
