4021470 Rev D D9854 Advanced Program Receiver Installation and Operation Guide 3-3
Section A - Rack Installation
General
Power Connection
To operate the receiver, you must connect it to an AC power source. For
information about connecting the chassis to AC power, see Appendix A - Technical
Specifications.
As Cisco units are designed for continuous operation, some products do not have a
power switch. In this case the mains cord and/or DC power supply cable serve(s) as
the mains disconnect device.
WARNING:
Make sure that at least one end of the power cable(s) remains easily accessible
for unplugging, if you need to switch off the unit. For example: Ensure that the
socket outlet is installed near the product.
WARNING:
To avoid electrical shock, connect the three-prong plug on this product to an
earth-grounded three-pin socket outlet only.
To Next Page
Loading...
