EasyManuals Logo

Cisco D9854 User Manual

Cisco D9854
344 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #81 background imageLoading...
Page #81 background image
4021470 Rev D D9854 Advanced Program Receiver Installation and Operation Guide 4-19
Status Menu: TS Input
Level (dBm)
Description: Indicates the signal level of the received signal.
Parameters: in dBm.
SymRate
Description: Indicates the Symbol Rate of the received signal.
Parameters: in Msymbols/second.
FEC
Description: Indicates the FEC (Forward Error Correction) rate of the received
signal.
Parameters: N/A, 1/2, 3/5, 2/3, 3/4, 4/5, 5/6, 7/8, 8/9 or 9/10.
Modulation
Description: Indicates the modulation type for the received signal.
Parameters: N/A, QPSK, 8PSK, DVB-S or DVB-S2.
IQ
Description: Indicates the IQ (Input Signal Inversion) for the received signal.
Parameters: Inv or NonInv.
Pol
Description: Indicates the signal polarization setting. This setting is only
applicable when LNB Power is set to H-NIT or V-NIT. The selected
setting must match the polarization of the transmitted signal.
Parameters: Horiz (Horizontal), Vert (Vertical) or Auto.
Dnlk Freq (GHz)
Description: Indicates the current downlink frequency.
Parameters: in GHz.
L-Band
Description: Indicates the current L-Band frequency.
Parameters: in MHz.
Pilot Present
Description: Indicates whether a Pilot is present for the received signal. The Pilot
is set on the modulator for input signal synchronization purposes.
Parameters: Yes or No.
C/N (dB)
Description: Indicates the current Carrier-to-Noise ratio.
Parameters: in dB.

Table of Contents

Other manuals for Cisco D9854

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco D9854 and is the answer not in the manual?

Cisco D9854 Specifications

General IconGeneral
ModelD9854
CategoryReceiver
OutputASI, IP
DecodingMPEG-2
Conditional AccessBISS
Receiver TypeProfessional IRD
解密DVB-CSA, BISS, AES
Input Frequency Range950 MHz to 2150 MHz
Modulation FormatsQPSK, 8PSK
Symbol Rate1 to 45 Msps
Power Supply100-240 VAC, 50/60 Hz
Power Consumption40W (typical)
Operating Temperature0°C

Related product manuals