Cisco D9854 User Manual

4-62 Model D9854 Advanced Program Receiver Installation and Operation Guide 4021470 Rev D
Setup Menu: Outputs
Structure
To view the Outputs menus from the Main menu, press the RIGHT arrow key once
and then the SELECT key to reach the Setup menu. Then press the RIGHT arrow
key four times and the SELECT key to view the Outputs menu.
The Outputs menu allows you to set up the rear panel control relays for alarms, cue
tones and cue triggers, and the transport stream outputs, Digital Program Mapping
(DPM) and transcoding.
For instructions on how to select and store settings, see About the Front Panel,
page 4-2.
The Outputs menu has the following structure:
Cueing
Cueing Mode Trigger Polarity
Trigger High
i
s
Repeat Tone(ms) Silence(ms)
3 40 40
i
s
Seq# State Tones Mode Delay(sec)
16 Disable 999 */# 255
i
s
Relay Mode Cue Trigger Bit
Trigger 1
i
s
MOIP1
MOIP Send SAP SAP ID
RTP Yes Channel Name String
i
s
DestAddr UDPPort SrcPort
192.131.244.111 12345 12345
i
s
TS/IP Min IP/s PCR@IP Start
8 1000000 Yes
i
s
MGMT Port Mode DATA Port Mode
Always Output Always Output
Main:Setup:Outputs:TS Out
ASI MOIP1 DPM
SAP Multicast Address PCR Addition
192.131.244.123 Yes
Instance Name
MPEG over IP 1
i
s
ASI
Name Rate Control User Rate(Mbps)
ASI User 213.0
i
s
Output Mode Descramble Mode
MAP Svc Chans Only Descrambled
i
s
Name Rate Control User Rate(Mbps)
MOIP1 User 213.0
i
s
Output Mode Descramble Mode
MAP Svc Chans Only Descrambled
i
s
Insert Null Packet
Yes
i
s
Insert Null Packet
Yes
i
s
i
s
i
s
i
s
MOIP Only
M1/ M2
M1 Port Type M2 Port Type
ASI SDI
i
s
SDI Only
Main:Setup:Outputs
Cueing TS Out M1/M2
i
s
Cue Tone Test Mode Run Test
999 */#
i
s

Cisco D9854 Specifications

General

Model	D9854
Category	Receiver
Output	ASI, IP
Decoding	MPEG-2
Conditional Access	BISS
Receiver Type	Professional IRD
解密	DVB-CSA, BISS, AES
Input Frequency Range	950 MHz to 2150 MHz
Modulation Formats	QPSK, 8PSK
Symbol Rate	1 to 45 Msps
Power Supply	100-240 VAC, 50/60 Hz
Power Consumption	40W (typical)
Operating Temperature	0°C