Cisco D9854 - Quick Setup Instructions for RF Acquisition

1-4 Model D9854 Advanced Program Receiver Installation and Operation Guide 4021470 Rev D
Quick Setup Instructions for RF Acquisition
1. Press MENU to display the Main menu.
2. Press
! to get to the Setup menu. Press SELECT. Press ! to move to the TS
Input menu. Press SELECT.
3. To setup the ASI input port, go to step 4. To setup the RF1 input port, go to step
5.
4. Press SELECT twice. Press
# to set the ASI port to Act (Activate). Press
SELECT. Press MENU three times to return to the start-up menu. Go to step 12.
5. Press SELECT. Press
! to go to RF1. Press SELECT twice. Use # to set the RF1
port parameter to Act (Activate). Press SELECT.
6. Press
# to move to the LO1, LO2, Xover menu. Verify these parameters for your
application. If no change is needed, go to Step 7. If required, you may modify
these settings. Use
! to move to the parameter that you want to modify. Press
SELECT. Use the numerical keypad to enter new frequencies. Press SELECT.
7. Press
# five times to move to the Modulation and Rolloff menu. Press SELECT.
Use
"# to choose DVB-S or DVB-S2. Press SELECT. If DVB-S2 is used, press
! to choose Rolloff. Press SELECT. Use "# to choose the value. Press
SELECT.
8. Press
" to move to the Freq., Sym Rate, and FEC menu. Press SELECT. Enter
the RF frequency. Press SELECT. Press
! to move to the Sym. Rate menu. Press
SELECT. Enter the symbol rate. Press SELECT. If DVB-S2 is used, proceed to
step 9. If DVB-S is used, press
! to go to FEC. Press SELECT. Use "# to select
AUTO. Press SELECT.
9. Press
# twice to move to the Net ID menu. Press ! to choose Net ID. Press
SELECT. Enter the value. Press SELECT.
10. Press
#. Press SELECT. Use "# to change the LNB power, if needed. Only the
RF1 port is capable of providing 13V or 18V. Press SELECT.
11. Press MENU three times. Press
! to move to Save & Exit. Press SELECT. Save
& Exit will return you to the Main: Setup menu; Abandon & Exit will go back to
the last menu accessed with the original parameters; Cancel will go back to the
last menu accessed with changes saved.
12. The receiver will search for the signal and display “Acquisition Successful”. It
will find the first available channel on the network. Press MENU twice to return
to the start-up menu.