Cisco D9854 User Manual

4021470 Rev D D9854 Advanced Program Receiver Installation and Operation Guide 4-83
Setup Menu: Outputs: TS Out: DPM, Continued
10. Press MENU three times to exit the TS Out menu and save the data. If the
changes cannot be saved/made, a message will be displayed indicating “Bad
configuration data”. The following options are available: Abandon, Exit or
Return. Select Return to re-enter the parameter.
Note: When remapping an input program channel to an output channel, ensure
that the PIDs are mapped to different PIDs to avoid PID collisions.
PE Resync: All, Template, PIDs, Svcs
Description: Each PE output can be synchronized to its input according to one of
four output modes.
Parameters: Services only (Svcs), PIDS only (PIDs), using a Template or All
(Services and PIDS).
Parameter Description
SIT Pass
ECM Drop
EMM Drop
DRT Drop
CDT Drop

Cisco D9854 Specifications

General

Model	D9854
Category	Receiver
Output	ASI, IP
Decoding	MPEG-2
Conditional Access	BISS
Receiver Type	Professional IRD
解密	DVB-CSA, BISS, AES
Input Frequency Range	950 MHz to 2150 MHz
Modulation Formats	QPSK, 8PSK
Symbol Rate	1 to 45 Msps
Power Supply	100-240 VAC, 50/60 Hz
Power Consumption	40W (typical)
Operating Temperature	0°C