Cisco D9854 User Manual

4-86 Model D9854 Advanced Program Receiver Installation and Operation Guide 4021470 Rev D
Setup Menu: CA, Continued
ADP Enc Pass
Description: Indicates the current Encrypted Addressed Data Packet Count. This
count indicates the amount of transmitted ADP information which
is being accurately received and processed. Ideally, the ADP Enc
Pass and ADP Enc Total numbers should be identical.
ADP Enc Total
Description: Indicates the total number of current Encrypted Addressed Data
Packet count. This count indicates the amount of transmitted ADP
information being accurately received and processed. Ideally, the
ADP Enc Pass and ADP Enc Total numbers should be identical.
ADP Non-Enc Pass
Description: Indicates the current Non-Encrypted Addressed Data Packet count.
This count indicates the amount of transmitted ADP information
being accurately received and processed. Ideally, the ADP Enc Pass
and ADP Enc Total numbers should be identical.
ADP Non- Enc Total
Description: Indicates the current Non-Encrypted Addressed Data Packet Count.
These counts indicate the amount of transmitted ADP information
which is being accurately received and processed. Ideally, the ADP
Non-Enc Pass and ADP Non-Enc Total numbers should be
identical.
Clear ADP Counts
Description: To help the operator make accurate analyses of the receiver's
functionality, the ADP Enc Pass, ADP Enc Total, ADP Non- Enc
Pass and ADP Non-Enc Total numbers can be cleared by using this
feature. These same values are also reset whenever the receiver is
turned on, reset or power-cycled.
Parameters: Yes, No.
BISS Mode
Description: This is used to set the Basic Interoperable Scrambling System (BISS)
mode for the receiver.
Parameters: Mode 1 or Mode E.
BISS-1 SW
Description: This used to set the BISS Mode 1, odd and even session words.
Parameters: You can enter the fixed 12-character Session Word (SW). Once
entered it cannot be viewed, only displayed as asterisks (*).
Contact your program provider for the respective session word
and/or injected ID.

Cisco D9854 Specifications

General

Model	D9854
Category	Receiver
Output	ASI, IP
Decoding	MPEG-2
Conditional Access	BISS
Receiver Type	Professional IRD
解密	DVB-CSA, BISS, AES
Input Frequency Range	950 MHz to 2150 MHz
Modulation Formats	QPSK, 8PSK
Symbol Rate	1 to 45 Msps
Power Supply	100-240 VAC, 50/60 Hz
Power Consumption	40W (typical)
Operating Temperature	0°C