5-46 Model D9854 Advanced Program Receiver Installation and Operation Guide 4021470 Rev D
Setting up the TS Output: MPEGoIP, Continued
10. Set the maximum number of transport packets per IP packet in Max TS/IP. You
can enter a value in the range from 1 to 7.
11. Select Yes in SAP to send Session Announcement Protocol messages. Otherwise,
select No.
12. In SAP String, enter the SAP identifier (ID)/string. You can enter up to 49
characters.
13. In Control Port Output and Data port Output, select the control and data
MPEGoIP modes.
Note: If No Output was selected in Output Mode for MOIP1 in TS Output (see
Configuring the Transport Stream: TS Output, page 5-33), updates to the port
modes will have no affect.
The following table displays the modes:
14. Click Save.
Control Mode
Data Mode
Description
No Output Disables the MPEGoIP interface.
IGMP Only outputs data when requested via IGMP.
Always Output Always outputs data on the port.
Note: You cannot select Always Output for both ports
simultaneously.
To Next Page
Loading...
