Cisco D9854 User Manual

Name: Cisco D9854
Brand: Cisco
Rating: 5 (1 reviews)

344 pages

To Next Page

To Previous Page

1-2 Model D9854 Advanced Program Receiver Installation and Operation Guide 4021470 Rev D

Connecting the Receiver, Continued

7. Connect the HD-SDI outputs (M1 and M2) to HD compatible signal processing

equipment or HD signal monitoring equipment, if applicable.

Maintenance of EMC Compliance

The power cord (consisting of appliance coupler, flexible cord, and plug) supplied

with this product meets the requirements for use in the country for which this

product was purchased. In general, the power cord must be approved by an

acceptable, accredited agency responsible for evaluation in the country where the

product will be used.

Double-shielded (braid/foil or braid/braid) cables should be used for all ASI I/O

and RF inputs. Single-shield cables are acceptable for all other inputs and outputs.

For terminal block (Alarms) I/O, no shielding is required.

Other manuals for Cisco D9854

Need help?

Do you have a question about the Cisco D9854 and is the answer not in the manual?

General