Cisco D9854 User Manual

4021470 Rev D D9854 Advanced Program Receiver Installation and Operation Guide 3-5
Installing the D9854 Receiver, Continued
To Connect AC Power
To connect AC power to the D9854 receiver do the following:
1. Connect the power cord (supplied with the D9854 receiver) between the rear
panel power receptacle and a 100 to 120/200 to 240 V AC power outlet.
2. Make sure that the power cable is connected to protective ground.
See Grounding, page 3-4 for more information.
The D9854 receiver is equipped with one power supply located in the rear of the
chassis. Note the location of the power supply in the event of alarms/warnings
resulting in replacement of a power supply. Alarm messages appear in the Message
Log.

Cisco D9854 Specifications

General

Model	D9854
Category	Receiver
Output	ASI, IP
Decoding	MPEG-2
Conditional Access	BISS
Receiver Type	Professional IRD
解密	DVB-CSA, BISS, AES
Input Frequency Range	950 MHz to 2150 MHz
Modulation Formats	QPSK, 8PSK
Symbol Rate	1 to 45 Msps
Power Supply	100-240 VAC, 50/60 Hz
Power Consumption	40W (typical)
Operating Temperature	0°C