Cisco D9854 User Manual

4021470 Rev D D9854 Advanced Program Receiver Installation and Operation Guide 3-17
Setting Admin User Privileges via a Telnet Connection, Continued
Changing a Password (allowed by all Users)
Passwords can be changed by all users.
To modify a password, type the following command:
pwd change_password < username> < new_password> <confirmed_password>
Note: The <new_password> and <confirmed_password> should be identical. Each
user, including the admin user, can modify only his own password.
Printing the List of Users
To print the list of users, type the following command:
pwd list_users
Note: Only usernames will be printed. Passwords will not be visible.
Resetting the Login Authentication Table
At any time the user authentication table can be reset from the front panel. This
option is under the Setup, IP menu. When the authentication table reset is required,
the username and password are reset to the software defaults. The username and
password defaults are as follows unless you have been provided customer-specific
defaults in addition to the one normally supplied.
Default username - admin
Default password - localadmin

Cisco D9854 Specifications

General

Model	D9854
Category	Receiver
Output	ASI, IP
Decoding	MPEG-2
Conditional Access	BISS
Receiver Type	Professional IRD
解密	DVB-CSA, BISS, AES
Input Frequency Range	950 MHz to 2150 MHz
Modulation Formats	QPSK, 8PSK
Symbol Rate	1 to 45 Msps
Power Supply	100-240 VAC, 50/60 Hz
Power Consumption	40W (typical)
Operating Temperature	0°C