4-32 Model D9854 Advanced Program Receiver Installation and Operation Guide 4021470 Rev D
Setup Menu: TS Input, Continued
ASI INPUT
ASI Active
Description: Sets the input to be active or inactive.
Parameters: Act or No.
Tune Mode
Description: Sets the mode used to build channel lists from allowed service lists.
Parameters: Auto, Basic, FixPID or Custom. The default is Basic.
CA Ctl
Description: Sets the type of CA (Conditional Access) to determine which
programs can be viewed via the receiver.
Parameters: Std (standard) for PowerVu signal or Open conditional access for
free-to-air (i.e., in-the-clear signals).
Select
Description: This sets the parameters the receiver uses for signal switching.
Parameters: RF Map or Preset. RF Map uses the orbital positioning settings to
find and lock onto a signal, while it can be ignored for Preset.
RF1, RF2, RF3, RF4
RFx INPUT
RFx Active (RF1, RF2, RF3, RF4)
Description: Sets the input to be active or inactive.
Note: Setting a new input to be Active will deactivate the currently
Active input.
Parameters: Act or No.
Tune Mode
Description: Sets the mode used to build channel lists from allowed service lists.
Parameters: Auto, Basic, FixPID, and Custom. The default is Basic.
CA Ctl
Description: Sets the type of CA (Conditional Access) to will determine which
programs can be viewed via the receiver.
Parameters: Std (standard) for PowerVu signal or Open conditional access for
free-to-air (i.e., in-the-clear signals).
Select
Description: This sets the parameters the receiver uses for signal switching.
Parameters: SW Map or UserCfg. SW Map uses the orbital positioning settings
to find and lock onto a signal, while it can be ignored for UserCfg.
To Next Page
Loading...
