4-34 Model D9854 Advanced Program Receiver Installation and Operation Guide 4021470 Rev D
Setup Menu: TS Input, Continued
E/W
Description: Denotes the satellite position the dish connected to the current RF
Input should point. This is used when the satellite is not available in
the look-up menu list.
Parameters: E, W or NA.
Pol
Description: Marks the polarity of the signal connected to this RF input.
Parameters: H (horizontal), Vert (vertical), A (Auto). Auto is only applicable for
This setting is only applicable when LNB Power is set to H-NIT or
V-NIT.
Validate Orbital Position
Description: This option allows you to configure and validate the RF inputs to
match those expected by the network. The receiver will check to see
if all the frequencies in the Network Information Table (NIT) can be
tuned to.
Parameters: Yes or No.
Orbital Position Validation Date
Description: This displays the last date that the ‘Validate Orbital Position’
operation was performed.
Parameters: N/A.
Freq (GHz)
Description: This is the current Downlink operating frequency used by the
receiver for tuning the received digital signal.
Parameters: 0.0 to 15.0 GHz.
SymRate
Description: This is the symbol rate. The symbol rate must match that of
transmitted signal.
Parameters: 1.0 to 45.0 Ms/s for DVB-S.
1.0 to 30.0 Ms/s for DVB-S2 if Pilot Present is set to Yes.
5.0 to 30.0 Ms/s for DVB-S2 if Pilot Present is set to No.
FEC
Description: This is the Forward Error Correction inner code rate. The FEC must
match the FEC of the transmitted signal.
Parameters: 1/2, 2/3, 3/4, 5/6, 7/8 for DVB-S or Auto for DVB-S2.
To Next Page
Loading...
Need help?
General
