Cisco WS-C6506 - Page 1043

40-49
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
OL-8978-04
Chapter 40 Configuring 802.1X Authentication
Configuring 802.1X Authentication on the Switch
supp-timeout 30 seconds
tx-period 30 seconds
Console> (enable)
To display the 802.1X authenticated MAC addresses, perform this task in normal mode:
This example shows how to display the 802.1X authenticated MAC addresses. In this example, both
802.1X and port security are enabled:
Console> (enable) show cam static 8/17
* = Static Entry. + = Permanent Entry. # = System Entry. R = Router Entry.
X = Port Security Entry $ = Dot1x Security Entry
VLAN Dest MAC/Route Des [CoS] Destination Ports or VCs / [Protocol Type]
---- ------------------ ----- -------------------------------------------
12 00-40-ca-13-ae-bf $ 8/17
17 00-30-94-c2-c3-c1 X 8/17
Total Matching CAM Entries Displayed =2
Console> (enable)
Task Command
Display the 802.1X authenticated MAC
addresses.
show cam static