EasyManua.ls Logo

Cisco WS-C6506 - Page 1083

Cisco WS-C6506
1488 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
43-5
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
OL-8978-04
Chapter 43 Tracking Host Aging
Configuring IP Device Tracking on a Port
This example shows how to enable IP device tracking on a port with MAC authentication bypass:
Console> (enable) set port mac-auth-bypass 3/1 ip-device-tracking enable
Port 3/1 ip-device-tracking option is enabled.
Console> (enable)
This example shows how to view the current configuration of IP device tracking on a port with MAC
authentication bypass:
Console> (enable) show port mac-auth-bypass 3/1
Port Mac-Auth-Bypass State MAC Address Auth-State Vlan
----- --------------------- ----------------- ----------------- -----
3/1 Enabled 00-00-00-00-00-00 waiting 1
Port Termination action Session Timeout Shutdown/Time-Left
----- ------------------ --------------- ------------------
3/1 initialize 300 NO -
Port PolicyGroups
----- -------------------------------------------------------------------
3/1 -
Port Security ACL Sec ACL Type QoS ACL Type
----- -------------------------------- ----------------- ----------------
3/1 - - -
Port QoS Ingress ACL QoS Egress ACL
----- -------------------------------- ----------------------------------
3/1 - -
Port Critical Critical-Status Ip-Device-Tracking
----- -------- --------------- ------------------
3/1 Disabled - Enabled
Port Session-ID
----- --------------------------------
3/1 -
Port Posture Token URL-Redirect
----- ------------- ---------------------------------
3/1 -
Enabling or Disabling IP Device Tracking on a Port with Web-Based Proxy
Authentication
To enable or disable IP device tracking on a port with web-based proxy authentication, perform this task
in privileged mode:
This example shows how to enable IP device tracking on a port with web-based proxy authentication:
Console> (enable) set port web-auth 3/1 ip-device-tracking enable
Task Command
Enable or disable IP device tracking on a module or port
with web-based proxy authentication. The default is
enabled.
set port web-auth mod/port
ip-device-tracking {disable | enable}

Table of Contents

Related product manuals