5-20
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
OL-8978-04
Chapter 5 Configuring Ethernet VLAN Trunks
Example VLAN Trunk Configurations
3/5 connected auto channel WS-C4003 JAB023806(Sw 2/5
3/6 connected auto channel WS-C4003 JAB023806(Sw 2/6
----- ---------- --------- ----------- ------------------------- ----------
Switch_B> (enable)
Step 5 Configure one of the ports in the EtherChannel bundle to negotiate an 802.1Q trunk by entering the set
trunk command. The configuration is applied to all of the ports in the bundle. This example assumes
that the neighboring ports on Switch B are configured to use dot1q or negotiate encapsulation and are
in auto trunk mode. The system logging messages provide information about the formation of the
802.1Q trunk.
Switch_A> (enable) set trunk 2/3 desirable dot1q
Port(s) 2/3-6 trunk mode set to desirable.
Port(s) 2/3-6 trunk type set to dot1q.
Switch_A> (enable) %DTP-5-TRUNKPORTON:Port 2/3 has become dot1q trunk
%DTP-5-TRUNKPORTON:Port 2/4 has become dot1q trunk
%PAGP-5-PORTFROMSTP:Port 2/3 left bridge port 2/3-6
%DTP-5-TRUNKPORTON:Port 2/5 has become dot1q trunk
%PAGP-5-PORTFROMSTP:Port 2/4 left bridge port 2/3-6
%PAGP-5-PORTFROMSTP:Port 2/5 left bridge port 2/3-6
%DTP-5-TRUNKPORTON:Port 2/6 has become dot1q trunk
%PAGP-5-PORTFROMSTP:Port 2/6 left bridge port 2/3-6
%PAGP-5-PORTFROMSTP:Port 2/3 left bridge port 2/3
%PAGP-5-PORTTOSTP:Port 2/3 joined bridge port 2/3-6
%PAGP-5-PORTTOSTP:Port 2/4 joined bridge port 2/3-6
%PAGP-5-PORTTOSTP:Port 2/5 joined bridge port 2/3-6
%PAGP-5-PORTTOSTP:Port 2/6 joined bridge port 2/3-6
Switch_B> (enable) %DTP-5-TRUNKPORTON:Port 3/3 has become dot1q trunk
%DTP-5-TRUNKPORTON:Port 3/4 has become dot1q trunk
%PAGP-5-PORTFROMSTP:Port 3/3 left bridge port 3/3-6
%PAGP-5-PORTFROMSTP:Port 3/4 left bridge port 3/3-6
%PAGP-5-PORTFROMSTP:Port 3/5 left bridge port 3/3-6
%PAGP-5-PORTFROMSTP:Port 3/6 left bridge port 3/3-6
%DTP-5-TRUNKPORTON:Port 3/5 has become dot1q trunk
%DTP-5-TRUNKPORTON:Port 3/6 has become dot1q trunk
%PAGP-5-PORTFROMSTP:Port 3/5 left bridge port 3/3-6
%PAGP-5-PORTFROMSTP:Port 3/6 left bridge port 3/3-6
%PAGP-5-PORTTOSTP:Port 3/3 joined bridge port 3/3-6
%PAGP-5-PORTTOSTP:Port 3/4 joined bridge port 3/3-6
%PAGP-5-PORTTOSTP:Port 3/5 joined bridge port 3/3-6
%PAGP-5-PORTTOSTP:Port 3/6 joined bridge port 3/3-6
To Next Page
Loading...
Need help?
General