46-11
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
OL-8978-04
Chapter 46 Configuring the Switch Fabric Modules
Configuring and Monitoring the Integrated Switch Fabric and Switch Fabric Module on the Switch
tftp:sysinfo
Index System Information Logging Commands
----- ---------------------------------------------------------
Syslog Dump Syslog File
------------------------ -------------------------------------------
disabled bootflash:sysloginfo
No profile is configured for the system
Console> (enable)
This example shows how to display backplane traffic and fabric channel input and output:
Console> (enable) show traffic
Threshold: 100%
Backplane-Traffic Peak Peak-Time
----------------- ---- -------------------------
0% 0% Tue Oct 19 2004, 12:04:18
Slot Channel Fab Chan Input Output
---- ------- -------- ----- ------
2 0 1 0% 0%
Console> (enable)
Displaying the Switching Mode Configuration
To display the switching mode configuration, perform this task:
This example shows how to display the switching mode configuration:
Console> show system switchmode
Switchmode allow:truncated
Switchmode threshold:2
Console> (enable)
Displaying the Integrated Switch Fabric Status
To display the integrated switch fabric status and forwarding speed, perform this task:
Task Command
Display the switching mode configuration. show system switchmode
Task Command
Display the integrated switch fabric status and
speed.
show fabric status
To Next Page
Loading...
