Cisco WS-C6506 - Page 1191

50-5
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
OL-8978-04
Chapter 50 Using Switch TopN Reports
Running and Viewing Switch TopN Reports
To remove the stored reports, perform this task in privileged mode:
Note Use the all keyword to remove all the completed reports. The command clear top all command does not
clear the pending reports; only the reports that have completed are cleared.
This example shows how to remove a specific report and how to remove all stored reports:
Console> (enable) clear top 4
Console> (enable) 06/16/1998,17:36:45:MGMT-5:TopN report 4 killed by Console//.
Console> (enable) clear top all
06/16/1998,17:36:52:MGMT-5:TopN report 1 killed by Console//.
06/16/1998,17:36:52:MGMT-5:TopN report 2 killed by Console//.
Console> (enable) 06/16/1998,17:36:52:MGMT-5:TopN report 3 killed by Console//.
06/16/1998,17:36:52:MGMT-5:TopN report 5 killed by Console//.
Console> (enable)
Task Command
Remove the reports. clear top {all | report_num}