52-78
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
OL-8978-04
Chapter 52 Configuring QoS
Configuring QoS on the Switch
This example shows how to display the QoS Layer 3 statistics:
Console> (enable) show qos statistics l3stats
Total packets Average Peak Rate
Rage(pps) (pps)
--------------- ---------- --------
Packets dropped due to policing: 621085 1289 3618
IP packets with ToS changed: 4495508 9937 18507
IP packets with CoS changed: 4495508 9937 18507
Non-IP packets with CoS changed: 0 0 0
Console> (enable)
This example shows how to display the QoS aggregate policer statistics:
Console> (enable) show qos statistics aggregate-policer ag1
QoS aggregate-policer statistics:
Aggregate policer Allowed packet Packets exceed
count excess rate
-------------------- --------------- ------------
ag1 2171253 411450
QoS aggregate-policer average rate statistics over 5 minutes:
Aggregate policer Allowed packet Traffic exceeding
count excess rate
-------------------- --------------- --------------
ag1 5399 1024
QoS aggregate-policer peak rate statistics over 5 minutes:
(collected every 30 seconds)
Aggregate policer Peak Allowed
rate (pps)
--------------- --------------
ag1 20802
For PFC3B- or PFC3BXL-based switches, the peak allowed packet count rate will not be displayed. The
peak byte count rate will be displayed as shown here:
Console> (enable) show qos statistics aggregate-policer ag1
QoS aggregate-policer statistics:
Aggregate policer Allowed byte Bytes exceed
count excess rate
-------------------- -------------- ------------
ag1 9992929900 2819929466
QoS aggregate-policer average rate statistics over 5 minutes:
Aggregate policer Allowed rate Traffic exceeding
(kbps) excess rate (kbps)
------------------------------- ---------------- ------------------------
ag1 152080 42911
QoS aggregate-policer peak rate statistics over 5 minutes:
(collected every 30 seconds)
Aggregate policer Peak Allowed
rate (pps)
--------------- --------------
ag1 218912
To Next Page
Loading...
