52-84
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
OL-8978-04
Chapter 52 Configuring QoS
Configuring QoS on the Switch
This example shows how to delete the PDP server configuration:
Console> (enable) clear cops server all
All COPS diff-serv servers cleared.
All COPS rsvp servers cleared.
Console> (enable)
Configuring the COPS Domain Name
The PDP servers use a COPS domain name to communicate with the policy enforcement point (PEP)
devices such as the switches. To configure a COPS domain name for the switch, perform this task in
privileged mode:
This example shows how to configure a COPS domain name:
Console> (enable) set cops domain-name my_domain
Domain name set to my_domain.
Console> (enable)
Deleting the COPS Domain Name
To delete the COPS domain name, perform this task in privileged mode:
This example shows how to delete the COPS domain name:
Console> (enable) clear cops domain-name
Domain name cleared.
Console> (enable)
Configuring the COPS Communications Parameters
To configure the parameters that COPS uses to communicate with the PDP server, perform this task in
privileged mode:
Task Command
Step 1
Configure the COPS domain name. set cops domain-name domain_name
Step 2
Verify the COPS domain name. show cops info
Task Command
Step 1
Delete the COPS domain name. clear cops domain-name
Step 2
Verify the configuration. show cops info
Task Command
Step 1
Configure the parameters that COPS uses to
communicate with the PDP server.
set cops retry-interval initial increment
maximum
Step 2
Verify the configuration. show cops info
To Next Page
Loading...
