EasyManua.ls Logo

Cisco WS-C6506

Cisco WS-C6506
1488 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
53-22
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
OL-8978-04
Chapter 53 Using Automatic QoS
Using the Automatic QoS Macro on the Switch
Port-Specific Automatic QoSvoip ciscosoftphone
Entering the port-specific automatic QoS command results in the following configuration:
set port qos mod/port autoqos voip ciscosoftphone
---------------
set port qos mod/port policy-source local
set port qos mod/port port-based
set port qos mod/port cos 0
set port qos mod/port cos-ext 0
set port qos mod/port trust-ext untrusted
set port qos mod/port trust-device none
set port qos mod/port trust untrusted
set qos policer aggregate POLICE_SOFTPHONE-DSCP46-mod-port rate 320 burst 20 policed-dscp
set qos policer aggregate POLICE_SOFTPHONE-DSCP26-mod-port rate 32 burst 8 policed-dscp
set qos acl ip ACL_IP-SOFTPHONE-mod-port trust-dscp aggregate
POLICE_SOFTPHONE-DSCP46-mod-port any dscp-field 46
set qos acl ip ACL_IP-SOFTPHONE-mod-port trust-dscp aggregate
POLICE_SOFTPHONE-DSCP26-mod-port any dscp-field 26
commit qos acl ACL_IP-SOFTPHONE-mod-port
set qos acl map ACL_IP-SOFTPHONE-mod-port mod/port
Port-Specific Automatic QoStrust cos
Entering the port-specific automatic QoS command results in the following configuration:
set port qos mod/port autoqos trust cos
---------------
set port qos mod/port policy-source local
set port qos mod/port port-based
set port qos mod/port cos 0
set port qos mod/port cos-ext 0
set port qos mod/port trust-ext untrusted
set port qos mod/port trust-device none
If the port type is 1q4t/2q2t, the configuration is as follows:
set qos acl ip ACL_IP-TRUSTCOS trust-cos any
commit qos acl ACL_IP-TRUSTCOS
set qos acl map ACL_IP-TRUSTCOS mode/port
set port qos mod/port trust trust-cos
If the port type is another port type, the configuration is as follows:
set port qos mod/port trust trust-cos
Port-Specific Automatic QoStrust dscp
Entering the port-specific automatic QoS command results in the following configuration:
set port qos mod/port autoqos trust dscp
---------------
set port qos mod/port policy-source local
set port qos mod/port port-based
set port qos mod/port cos 0
set port qos mod/port cos-ext 0
set port qos mod/port trust-ext untrusted
set port qos mod/port trust-device none

Table of Contents

Related product manuals