Cisco WS-C6506 - Page 1371

54-15
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
OL-8978-04
Chapter 54 Configuring ASLB
Configuring ASLB on the Switch
To commit your ASLB configuration settings, perform this task in privileged mode:
This example shows how to commit the ASLB configuration settings:
Console> (enable) commit lda
Commit operation in progress...
Successfully committed Local Director Accelerator.
Console> (enable)
Displaying the ASLB Configuration
Note Entering the show lda command without a keyword (committed | uncommitted) displays the
committed configuration settings.
To display the committed or uncommitted ASLB configuration settings, perform this task in privileged
mode:
This example shows how to display the committed ASLB configuration settings:
Console> (enable) show lda committed
Status:Committed
Virtual IP addresses:
Local Director Flow:10.0.0.8/ (TCP port 8)
Router MAC:
00-23-45-67-ee-7f
LD MAC:00-11-22-33-55-66
LD Router Side:
---------------
Router and LD are on VLAN 110
LD is connected to switch port 4/26 on VLAN 110
LD Server Side:
---------------
Server(s) and LD are on VLAN 105
LD is connected to switch port 4/40 on VLAN 105
Console> (enable)
Task Command
Commit your ASLB configuration
settings.
commit lda
Task Command
Display the committed or uncommitted
ASLB configuration settings.
show lda [committed | uncommitted]