55-12
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
OL-8978-04
Chapter 55 Configuring a VoIP Network
Configuring VoIP on a Switch
This section describes the following topics:
• Using show Commands to Display Module Type and Version Information, page 55-12
• Power Management Modes, page 55-13
• Phone Detection Summary, page 55-16
• Setting the Power Mode of a Port or a Group of Ports, page 55-17
• Setting the Default Power Allocation, page 55-17
• Setting the Inline Power Notification Threshold for a Module, page 55-18
• Displaying the Power Status for Modules and Individual Ports, page 55-18
• Displaying the Switch Power Environment for Modules, page 55-19
Using show Commands to Display Module Type and Version Information
To determine if the module has a voice daughter card installed, enter the show module command and
look at the “Sub” field. For example, in the following display, the 10/100BASE-TX module in slot 3 has
a voice daughter card.
To display the module status and information, perform this task in normal mode:
This example shows a submodule field that provides information about the submodules. The inline
power daughter card that is installed on module 3, as shown in the display, is WS-F6K-SVDB-FE, and
the inline power daughter card that is installed on module 6, as shown in the display, is
WS-F6K-VPWR-GE-TX.
Console> (enable) show module
Mod Slot Ports Module-Type Model Sub Status
--- ---- ----- ------------------------- ------------------- --- --------
1 1 2 1000BaseX Supervisor WS-X6K-SUP2-2GE yes ok
3 3 48 10/100BaseTX Ethernet WS-X6548-RJ-45 yes ok
4 4 48 10/100BaseTX Ethernet WS-X6148-RJ45V no ok
6 6 48 10/100/1000BaseT Ethernet WS-X6148-GE-TX yes ok
Mod Module-Name Serial-Num
--- -------------------- -----------
1 SAD04460M9G
3 SAD0447099V
4 SAD061901FL
6 SAD0706025A
Mod MAC-Address(es) Hw Fw Sw
--- -------------------------------------- ------ ---------- -----------------
1 00-d0-c0-d4-04-4e to 00-d0-c0-d4-04-4f 1.1 6.1(2) 7.7(0.82-Eng)
00-d0-c0-d4-04-4c to 00-d0-c0-d4-04-4d
00-02-4a-30-88-00 to 00-02-4a-30-8b-ff
3 00-02-b9-ff-eb-70 to 00-02-b9-ff-eb-9f 0.203 6.3(1) 8.2(1)
4 00-00-00-00-00-00 to 00-00-00-00-00-2f 1.3 5.4(2) 7.7(0.81)
6 00-40-0b-ff-00-00 to 00-40-0b-ff-00-2f 0.304 7.2(1) 8.2(1)
Task Command
Display the module status and information. show module [mod]
To Next Page
Loading...
