Cisco WS-C6506 - Page 1452

Index
IN-4
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
OL-8978-04
disabling 12-9
autostate
configuring
exclude mode
12-7
track mode 12-8
displaying configuration 12-8
overview 12-6
exclude mode 12-6
normal mode 12-6
track mode 12-7
auxiliary VLANs
configuring
55-20
disabling auxiliary VLANs until an IP phone is
detected
55-22
dynamic port VLAN membership 19-14
overview 55-8
with 802.1X authentication 40-8
B
BackboneFast 9-4
disabling 9-19
displaying statistics 9-18
enabling 9-18
figure
adding a switch
9-6, 9-7
after indirect link failure 9-5
before indirect link failure 9-5
multiple spanning tree 7-17
back-end authenticator-to-supplicant 40-21
backplane
threshold detection
20-20
banner
See login banner
blocking transitions
20-23
BOOT environment variables
clearing
25-11, 25-12
default 25-5
displaying 25-12
overview 25-3, 25-4
setting 25-10, 25-11
boot field
overview
25-3
setting 25-6
boot image and switch 23-3
booting
configuration register, setting value
25-10
from Melody Compact Flash 3-5
ignoring NVRAM 25-9
booting the MSFC for the first time 3-4
BOOTP and in-band (sc0) interface 3-10
Bootstrap Protocol
See BOOTP
BPDU
skewing
7-59
overview 7-24
BPDU Filter
multiple spanning tree
7-17
BPDU guard
disabling
9-12, 9-15
enabling 9-11, 9-14
multiple spanning tree 7-17
note 9-11
BPDU overview 7-3
BPDU skewing
monitoring
20-23
Break key (note) 2-1
bridged flow statistics 14-28, 16-3
bridge ID and MAC addresses 7-14
bridge ID priority, PVST+ 7-27
bridge protocol data units
See BPDUs
broadcast suppression
35-1
disabling 35-4
enabling 35-3
enabling errdisable state 35-4
suppressing multicast traffic 50-7
suppressing unicast traffic 35-2