Index
IN-9
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
OL-8978-04
software images
example, multiple module
27-13, 27-20
example, single module 27-12, 27-20
example, supervisor engine 27-9, 27-18
overview 27-5
preparation 27-16
preparing for 27-7, 27-23
supervisor engine 27-7, 27-16, 27-23
switching module 27-8, 27-17
Xmodem or Ymodem 27-33
drop thresholds
See QoS congestion avoidance
DSCP
See QoS DSCP
DTP
non-Cisco devices and
5-4
overview 5-2
duplex, Ethernet 4-6
DWRR 51-66
dynamic ARP inspection
See DAI
Dynamic Host Configuration Protocol
See DHCP
Dynamic Host Configuration Protocol snooping
See DHCP snooping
dynamic interswitch link (DISL) protocol
See DTP
dynamic port VLAN membership
configuring
19-5
default configuration 19-2
example 19-12
for auxiliary VLANs 19-14
overview 19-1
reconfirming 19-7
troubleshooting 19-10
Dynamic Trunking Protocol
See DTP
E
efficiency
PoE daughter cards
55-15
enable mode 2-9
enable password
recovering lost
39-16
setting 39-15
enabling 40-23
MLS, on MSFC interfaces 14-16
enabling IP MMLS
on MSFC interfaces
13-20, 14-33
encapsulation type descriptions, trunks (table) 5-3
environmental monitoring
LED indications
22-15
SNMP traps 22-15
supervisor engine and switching modules 22-15
syslog messages 22-15
using CLI commands 22-14
environment variables
See BOOT environment variables
EPLD images, upgrading
27-2
errdisable state, using with broadcast suppression 35-4
errdisable timeout, configuring 4-12
error detection, configuring 4-16
error messages
system message logging (syslog)
29-1
VMPS (table) 19-9
EtherChannel
administrative groups
6-7
bundling 6-2
channel modes (table)
LACP
6-13
PAgP 6-6
clearing and restoring channel counters 6-20
configuration guidelines 6-3
configuring
port modes
6-8
port path cost 6-9
To Next Page
Loading...
