Cisco WS-C6506 - Page 1461

Index
IN-13
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
OL-8978-04
VLAN assignment 11-2
in-band (sc0 and sc1) interface
configuring
3-7
feature comparison 3-6
IP address, assigning 3-7
overview 3-1, 3-4
inline power
efficiency
55-15
interface configuration mode 2-9
interfaces
in-band (sc0)
11-2
in-band (sc0 and sc1) 3-4, 3-7
SLIP (sl0) 3-4, 3-9
Internal Sub Tree Protocol
See ISTP
7-16
Internet Group Management Protocol
See IGMP
Internet Protocol
See IP addresses
interVLAN routing
AppleTalk, configuring
12-4
IP, configuring 12-3
IPX, configuring 12-3
overview 12-1
IOS
bringing up interface
2-11
viewing and saving configuration 2-11
IOS ACLs 15-3
common uses for 15-9
configuring counters 15-81
configuring rate limiting for Cisco IOS ACL
Logging
15-14
features
supported in PFC
15-10
supported in PFC II 15-13
unsupported 15-44
hardware and software handling in PFC 15-10
hardware and software handling in PFC2 15-13
hardware requirements 15-2
overview 15-2
reflexive ACLs with PFC 15-11
reflexive ACLs with PFC2 15-15
supported features 15-10, 15-13
with VACLs 15-17
IP
accounting, IP MMLS and
14-15
CIDR and 22-8
configuring interVLAN routing 12-3
default gateway, configuring 3-8
static routes 22-8
subnetworks, VLANs and 11-2
IP addresses
adding to IP permit list
37-2
aliases, creating 22-7
automatic assignment 3-2
BOOTP 3-10
clearing from IP permit list 37-5
designating 2-6
DHCP 3-10
in-band (sc0 and sc1) interface 3-7
obtaining from DHCP, BOOTP or RARP 3-10
RARP 3-10
setting on supervisor engine 3-7
SLIP (sl0) interface 3-10
IP aliases
creating
22-7
designating 2-6
IP CEF
topology (figure)
13-10
IP device tracking 43-1 to 43-6
IP-directed broadcasts, configuring 13-36
ip flow-export destination command 16-11
ip flow-export source command 16-11
IP MLS or IP MMLS
See MLS
ip mtu command
14-14
IP multicast
broadcast suppression