Index
IN-24
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
OL-8978-04
overview 22-12
powering modules up or down 22-14
setting default allocation for a port 55-17, 55-18
setting the inline power notification threshold for a
module
55-18
voice 55-11
PRBS test 20-10
private VLANs 11-19
community VLAN 11-20
configuration guidelines 11-21
configuring ACLs 15-43
creating 11-25
delete mapping 11-29
deleting 11-28
deleting isolated, community, or two-way community
VLANs
11-29
hardware/software interactions 11-22
isolated VLAN 11-20
primary VLAN 11-20
two-way community VLAN 11-20
using with 802.1X authentication 40-41
privileged EXEC mode 2-9
prompt
configuring
22-3
overview 22-2
protocol data units
See PDU
protocol filtering
configuring
36-3
default configuration 36-2
disabling 36-3
enabling 36-3
overview 36-1
protocol support 36-2
protocol tunneling
configuration guidelines
8-7
configuring 8-7
understanding 8-6
pruning, VTP
See VTP, pruning
PVST+
7-26
bridge ID priority, configuring 7-27
default configuration 7-26
default port cost mode 7-29
disabling 7-32
port cost 7-28
port priority 7-29
port VLAN priority 7-31
Q
QoS
(note)
15-3
COPS
See COPS
receive queue
See also automatic QoS
52-1
See automatic QoS
statistics data export
51-29
configuring 51-89
configuring destination host 51-93
configuring time interval 51-92
displaying information 51-93
trust-cos
port keyword
51-12
trust-dscp
port keyword
51-12
trust-ipprec
port keyword
51-12
QoS ACE
ICMP, creating
51-48
ICMP, options 51-19
IGMP, creating 51-49
IGMP, options 51-21
IP addresses and masks 51-46
IP Layer 3 options 51-18
IP Layer 4 port options 51-47
IP Layer 4 protocol options 51-18
To Next Page
Loading...
