18-6
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
OL-8978-04
Chapter 18 Configuring MVRP
Configuring MVRP on the Switch
This example shows how to configure normal registration on an 802.1ak trunk port:
Console> (enable) set port mvrp 3/1 registration normal
Registrar Administrative Control set to normal on port(s) 3/1.
Console> (enable)
Configuring MVRP Fixed Registration
Configuring an 802.1ak trunk port in fixed registration mode ignores further MVRP requests and
messages while retaining all existing registrations on the trunk port.
Note The registration is fixed for all configured VLANs on the port.
To configure MVRP fixed registration on an 802.1ak trunk port, perform this task in privileged mode:
This example shows how to configure fixed registration on an 802.1ak trunk port:
Console> (enable) set port mvrp 3/1 registration fixed
Registrar Administrative Control set to fixed on port(s) 3/1.
Console> (enable)
Configuring MVRP Forbidden Registration
Configuring an 802.1ak trunk port in forbidden registration mode deregisters all the VLANs (except
VLAN 1) on the trunk port.
To configure MVRP forbidden registration on an 802.1ak trunk port, perform this task in privileged
mode:
This example shows how to configure forbidden registration on an 802.1ak trunk port:
Console> (enable) set port mvrp 3/1 registration forbidden
Registrar Administrative Control set to forbidden on port(s) 3/1.
Console> (enable)
Task Command
Step 1
Configure fixed registration on an 802.1ak trunk
port.
set port mvrp mod/port registration fixed
Step 2
Verify the configuration. show mvrp configuration
Task Command
Step 1
Configure forbidden registration on an 802.1ak
trunk port.
set port mvrp mod/port registration forbidden
Step 2
Verify the configuration. show mvrp configuration
To Next Page
Loading...
Need help?
General