Cisco WS-C6506 - Page 610

20-34
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
OL-8978-04
Chapter 20 Checking Status and Connectivity
Configuring IEEE 802.3ah Ethernet OAM
Successfully cleared OAM statistics on port(s) 2/1-2,3/1-48,8/1-8.
Console> (enable)
This example shows how to clear OAM statistics from a specific port:
Console> (enable) clear port ethernet-oam 3/1 statistics
Successfully cleared OAM statistics on port(s) 3/1.
Console> (enable)
Clearing User-Configured Parameters for OAM Link Monitoring
When you clear the high-threshold or low-threshold parameters, the associated action is also cleared.
To clear the user-configured parameters for OAM link monitoring on the specified ports, perform this
task in privileged mode:
These examples show how to clear the user-configured parameters for OAM link monitoring on the
specified port:
Console> (enable) clear port ethernet-oam 3/1 link-monitor frame high-threshold
Successfully cleared OAM frame-period high-threshold on port(s) 3/1.
Console> (enable)
Console> (enable) clear port ethernet-oam 3/1 link-monitor frame-period window
Successfully cleared OAM frame-period window on port(s) 3/1.
Console> (enable)
Clearing User-Configured Actions for OAM Critical Link Events
To clear the user-configured actions for OAM critical link events on the specified ports, perform this task
in privileged mode:
These examples show how to clear the user-configured actions for OAM critical link events on the
specified port:
Console> (enable) clear port ethernet-oam 3/1 link-fault action
Successfully cleared OAM link-fault action on port(s) 3/1.
Console> (enable)
Console> (enable) clear port ethernet-oam 3/1 critical-event action
Successfully cleared OAM critical-event action on port(s) 3/1.
Console> (enable)
Task Command
Clear the user-configured parameters for OAM
link monitoring on the specified ports.
clear port ethernet-oam mod/port link-monitor
{symbol-period | frame | frame-period}
{high-threshold | low-threshold | window}
Task Command
Clear the user-configured actions for the OAM
critical link events on the specified ports.
clear port ethernet-oam mod/port
{critical-event | dying-gasp | link-fault} action