Cisco WS-C6506 - Page 613

20-37
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
OL-8978-04
Chapter 20 Checking Status and Connectivity
Configuring IEEE 802.3ah Ethernet OAM
This example shows how to display information about the OAM remote loopback test for the current
session:
Console> (enable) show port ethernet-oam 1/2 remote-loopback current-session
Port Loopback at OAM Rx OAM Tx
---- ----------- ---------- ----------
1/2 Remote 33333 55555
Console> (enable) show port ethernet-oam 1/2 remote-loopback current-session detail
Port: 1/2
Loopback: Remote OAM in loopback mode
Start: Mon Aug 1 2005, 07:30:59
End: Still running
Test statistics:
OAM Rx: 10000
OAM Tx: 10000
MAC Rx: 13415
MAC Tx: 13403
OAMPDU Rx: 3415
OAMPDU Tx: 3403
MAC Rx Drop: 0
Console> (enable)
This example shows how to display information about the OAM remote loopback test for the last session:
Console> (enable) show port ethernet-oam 1/2 remote-loopback last-session
Port Last Loopback at OAM Rx OAM Tx
---- ---------------- ---------- ----------
1/2 Remote 33333 55555
Console> (enable) show port ethernet-oam 1/2 remote-loopback last-session detail
Port: 1/2
Last Loopback: Remote OAM in loopback mode
Start: Mon Aug 1 2005, 07:30:59
End: Mon Aug 1 2005, 08:29:07
Test statistics:
OAM Rx: 10000
OAM Tx: 10000
MAC Rx: 13459
MAC Tx: 13448
OAMPDU Rx: 3459
OAMPDU Tx: 3448
MAC Rx Drop: 0
Test statistics reported by remote peer:
OAM Rx: 10000
OAM Tx: 10000
MAC Rx: 13448
OAMPDU Rx: 3448
MAC Rx Drop: 0
Console> (enable)