Cisco WS-C6506 - Page 628

20-52
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
OL-8978-04
Chapter 20 Checking Status and Connectivity
Configuring Metro Ethernet Connectivity Fault Management
Traceroute to 00-50-3e-78-fb-fb on Domain dom3, Level 3,
Vlan 2000 issued at Wed Aug 12 2009, 03:12:17
B = Intermediary Bridge
! = Target Destination
* = Per hop Timeout
--------------------------------------------------------------------------------
MAC Ingress Ingr Action Relay Action
Hops Host Forwarded Egress Egr Action Prev Hop
--------------------------------------------------------------------------------
B 1 y69 00-12-da-66-76-3b 4/13 IngOK RlyMPDB
Forwarded 00-0f-f8-8d-cb-fb
B 2 y72 00-0f-f8-8a-d0-7b RlyMPDB
Forwarded 3/5 EgrOK 00-12-da-66-76-3b
! 3 y90 00-50-3e-78-fb-fb RlyHit
Not Forwarded 00-0f-f8-8a-d0-7b
Clearing a Metro Ethernet CFM
To clear CFM parameters, perform one of these tasks in privileged mode:
This example shows how to clear an Ethernet CFM CC level on a VLAN:
Console> (enable) clear ethernet-cfm continuity-check level 3 vlan 1
cc attributes are cleared for level(s) 3
Console> (enable)
This example shows how to clear an Ethernet CFM domain:
Console> (enable) clear ethernet-cfm domain test level 1
Domain test is cleared from level 1.
Console> (enable)
Clearing a Metro Ethernet CFM Maintenance Association
To clear the maintenance association configured within the maintenance domain, perform one of these
tasks in priviledged mode:
Task Command
Clear a Metro Ethernet CFM domain. clear ethernet-cfm domain domain_name level
level.
Clear a Metro Ethernet CFM CC information. clear ethernet-cfm continuity-check level level
vlan vlan.
Task Command
Clear the CFM configured within a maintenance
domain.
clear ethernet-cfm maintenance-association
domain domain-name
Clear the maintenance association name used to
construct the Maintenance Association ID
(MAID) to be used in CFM frames.
clear ethernet-cfm maintenance-association
ma-name-fmt ma_fmt ma-name domain
domain-name