Cisco WS-C6506 - Page 731

23-39
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
OL-8978-04
Chapter 23 Configuring Redundancy
MSFC Redundancy
This message, which acknowledges that the high-availability redundancy is enabled and that the
configuration mode is automatically exited, is displayed on the nondesignated MSFC:
00:18:57: %RUNCFGSYNC-6-SYNCEVENT:
The High-Availability Redundancy Feature is enabled
The config mode is no longer accessible
Router-15#
00:19:41: %RUNCFGSYNC-6-SYNCEVENT:
Non-Designated Router is now online
Running Configuration Synchronization will begin in 1 minute
A 1-minute timer will start, allowing for the nondesignated MSFC to stabilize. When the timer expires,
a snapshot of the current running configuration is sent to the nondesignated MSFC. This message is
displayed before the running configuration is synchronized:
00:20:41: %RUNCFGSYNC-6-SYNCEVENT:
Syncing Running Configuration to the Non-Designated Router
00:20:41: %RUNCFGSYNC-6-SYNCEVENT:
Syncing Startup Configuration to the Non-Designated Router
These examples show that the designated MSFC and nondesignated MSFC have the same running
configuration after synchronization:
<designated MSFC>
Router-16# show running-config
Building configuration...
Current configuration:
!
version 12.1
service timestamps debug uptime
service timestamps log uptime
no service password-encryption
!
hostname Router-15 alt hostname Router-16
!
boot bootldr bootflash:c6msfc-boot-mz.120-7.XE1
!
ip subnet-zero
!
ip cef
redundancy
high-availability
config-sync
cns event-service server
!
!
!
interface Vlan1
ip address 70.0.70.4 255.255.0.0 alt ip address 70.0.70.5 255.255.0.0
!
interface Vlan10
ip address 192.10.10.1 255.255.255.0 alt ip address 192.10.10.2 255.255.255.0
no ip redirects
shutdown
standby ip 192.20.20.1 alt standby ip 192.20.20.1
!
ip classless
ip route 223.255.254.0 255.255.255.0 70.0.100.0
no ip http server
!