Cisco WS-C6506 - Page 790

27-4
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
OL-8978-04
Chapter 27 Working with System Software Images
Upgrading the EPLD Images
This example shows how to upgrade the EPLD image on the module in slot 5:
Console> (enable) download epld aq_cr128_art.bin 5 force
CCCCCC
Device found requiring upgrade in slot 5.
########################################################
# W A R N I N G #
# #
# Any disruptions to the module during programming may #
# leave the module or system in an inconsistent state. #
# Please ensure that the system or module does not get #
# switched off or reset during the programming process.#
# Programming may take a minute or two, depending on #
# the number of devices updated. Please wait for the #
# module to come back online before continuing. #
# #
# W A R N I N G #
########################################################
This command may reset module 5.
Updating fabric modules may significantly affect system performance while the update is
occurring.
Do you wish to update the devices in slot 5 (y/n) [n]? y
Updating programmable devices in slot 5. This may take a minute...
Programming successful, updating EPLD revisions.
2002 Aug 09 06:32:22 %SYS-4-NVLOG:EpldUpdate:Module 5 EPLD A updated from rev 1 to rev 1
Waiting for module to come online.
..........2002 Aug 09 06:32:33 %SYS-5-MOD_OK:Module 5 is online
.
################################################################################
E P L D P R O G R A M M I N G C O M P L E T E
Found 1 devices requiring upgrades, 1 attempted, 1 updated, 0 failed
################################################################################
Console> (enable) 2002 Aug 09 06:32:34 %SYS-4-NVLOG:EpldUpdate:Module 5 EPLD A s
prom updated to rev 1
Console> (enable)