29-16
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
OL-8978-04
Chapter 29 Configuring System Message Logging
Configuring CallHome
To clear the “from” address, perform this task in privileged mode:
This example shows how to clear the “from” address:
Console> (enable) clear logging callhome from
Cleared the from address field of callhome messages.
Console> (enable)
To clear the “reply to” address, perform this task in privileged mode:
This example shows how to clear the “reply to” address:
Console> (enable) clear logging callhome reply-to
Cleared the reply-to address field of callhome messages.
Console> (enable)
To clear an SMTP server from the list of CallHome SMTP servers, perform this task in privileged mode:
This example shows how to delete the SMTP server 172.20.8.16 from the list of CallHome servers:
Console> (enable) clear logging callhome smtp-server 172.20.8.16
Removed 172.20.8.16 from the table of callhome SMTP servers.
Console> (enable)
To clear the CallHome severity level, perform this task in privileged mode:
This example shows how to clear the CallHome severity level:
Console> (enable) clear logging callhome severity
Cleared callhome severity level to its default value of 2(LOG_CRIT).
Console> (enable)
Task Command
Clear the “from” address. clear logging callhome from
Task Command
Clear the “reply to” address. clear logging callhome reply-to
Task Command
Clear an SMTP server. clear logging callhome smtp-server IP
Address
Task Command
Clear the CallHome severity level. clear logging callhome severity
To Next Page
Loading...
