39-40
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
OL-8978-04
Chapter 39 Configuring the Switch Access Using AAA
Configuring Authentication on the Switch
Disabling Credentials Forwarding
To disable the credentials forwarding, perform this task in privileged mode:
This example shows how to disable the credentials forwarding and verify the change:
Console> (enable) clear kerberos credentials forward
Kerberos credentials forwarding disabled
Console> (enable) show kerberos
Kerberos Local Realm not configured
Kerberos server entries:
Kerberos Domain<->Realm entries:
Kerberos Clients NOT Mandatory
Kerberos Credentials Forwarding Disabled
Kerberos Pre Authentication Method set to None
Kerberos config key:
Kerberos SRVTAB Entries
Console> (enable)
To clear the Kerberos clients mandatory configuration, perform this task in privileged mode:
This example shows how to clear the clients mandatory configuration and verify the change:
Console> (enable) clear kerberos clients mandatory
Kerberos clients mandatory cleared
Console> (enable) show kerberos
Kerberos Local Realm not configured
Kerberos server entries:
Kerberos Domain<->Realm entries:
Kerberos Clients NOT Mandatory
Kerberos Credentials Forwarding Disabled
Kerberos Pre Authentication Method set to None
Kerberos config key:
Kerberos SRVTAB Entries
Console> (enable)
Kerberos server entries:
Kerberos Domain<->Realm entries:
Kerberos Clients Mandatory
Kerberos Credentials Forwarding Disabled
Kerberos Pre Authentication Method set to Encrypted Unix Time Stamp
Kerberos config key:
Kerberos SRVTAB Entries
Console> (enable)
Task Command
Disable the credentials forwarding configuration. clear kerberos credentials forward
Task Command
Clear the Kerberos clients mandatory
configuration.
clear kerberos clients mandatory
To Next Page
Loading...
