Citizen CT-S280 - Page 206

- 205 -
CT-S2000
• Setting MSW 1 (a=1)
n b (Set Value) Function
48 (Default) Reports the power on.
1
49 Does not report power on.
48 (Default) Sets input buffer capacity to 4K bytes.
2
49 Sets input buffer capacity to 45 bytes.
48 (Default) Sets input buffer full and offline to be Busy.
3
49 Sets to be busy with input buffer full.
48 (Default)
At the occurrence of receiving error, replaces the data with
“?”.
4
49 At the occurrence of receiving error, ignores the data.
48 (Default) Disables CR (0DH).
5
49 Enables CR (0DH).
6 48 (Default) Reserved
48 (Default) Does not reset at serial I/F pin 6.
7
49 Resets at serial I/F pin 6.
48 (Default) Does not reset at serial I/F pin 25.
8
49 Resets sat serial I/F pin 25.
* With MSW1-2, parallel I/F (4K fixed) and USB I/F (16K fixed) are disabled.
With serial I/F, 45 bytes are enabled only when DMA control (MSW7-6) is
disabled.
• Setting MSW 2 (a=2)
n b (Set Value) Function
1 49 (Default) Reserved
48 Disables auto cutter.
2
49 (Default) Enables auto cutter.
48 (Default) Enables stored printing.
3
49 Disables stored printing.
48 (Default) Immediately after digit reaches full, line-feed is taken.
4
49 Immediately after digit reaches full, data wait is taken.
48 (Default) After cover close and PE recovery, prints as it is.
5
49
After cover close and PE recovery, prints from the beginning
using PAGE MODE, barcode, image, double-height printing,
etc. as a unit.
6 48 (Default) Reserved
7 48 (Default) Reserved
48 (Default) Enables PNE.
8
49 Disables PNE.
• Setting MSW 3 (a=3)
n b (Set Value) Function
48 (Default) After clearing cutter error, can be restored by Feed SW.
1
49 After clearing cutter error, cannot be restored by Feed SW.
2 48 (Default) Reserved
48 (Default) Resets with parallel pin 31.
3
49 Does not reset with parallel pin 31.
4 48 (Default) Reserved
5 48 (Default) Reserved
6 48 (Default) Reserved
48 (Default) Sets EPSON compatible mode.7
49 Sets CBM1000-compatible mode.
48 (Default)
Sets cover open error during printing to be auto recovery
error.
8
49
Sets cover open error during printing to be recoverable
error.
• Setting MSW 4 (a=4) (Standard model)
n b (Set Value) Function
48 (Default)
At the selection of Black mark/Label paper, disables auto
end-measurement.
1
49
At the selection of Black mark/Label paper, enables auto
end-measurement.
48 (Default) Finding top of form at power ON disabled.
2
49 Finding top of form at power ON enabled.
48 Feed & Cut at TOF disabled.
3
49 (Default) Feed & Cut at TOF enabled.
4 48 (Default)
Reserved
5 48 (Default) Reserved
6 48 (Default) Reserved
7 48 (Default)
Reserved
48 Cut method is determined according to the cut command.
8
49 (Default)
Partial cut is performed regardless of cut command. (full
but by command: enabled).